Welcome to TONGLI Machinery

Installation of Honeycomb Coal Briquette Machine

Honeycomb coal briquette machine is mainly used to make the coal briquettes in honeycomb shapes. Previously raw coal been processed into the coal sphere slightly larger than ping-pong, and later the coal processed into one cylinder, and marked with a number of holes inside the cylinder makes it seems like honeycomb, because it can increase the surface area of coal, so that the full combustion of coal, to reduce resource waste. Mostly it is used in coal, metallurgical powder, powder cold-pressing ball, refractory materials.

Installation of honeycomb coal briquette machine:
 
1. Fasten the machine on solid cement floor
 
2. Clean the sundries around the machine and fill lubricating oil in transmission part
 
3. Check whether the screws are loose
 
4. Adjust the punch, run belt by hand; make sure every part goes well
 
5. The main engine should run clockwise, do not reverse it, before starting, remove the belt and test the direction of the motor, the direction of motor and big wheel should be consistent.
 
6. Put belt on and trail
 
7. Check whether there is unusual noise or phenomenon by point move method
 
8. If the machine runs normally, start to produce
 
9. Maintain the machine and fill lubricating oil regularly
 
10. Anything unexpected happens, cut power immediately

For more information, please view our website or contact us via the following Email.

Homepage/ http://www.charcoalequipment.com
E-mail/ tonglimachine5@cncharcoalmachine.com